What Size Slab Seats Six People
The length and width a six-seat dining table needs, worked from place settings and chair clearance rather than guesswork.
Six is the size most people ask for, and it is the size most often got wrong. A table that is long enough on paper can still be unusable, because the width was too narrow or the room could not take the chairs. Here is how to work it out properly, in the order the decisions actually depend on each other.
Start with the place setting
One adult needs roughly 60 cm of table edge to eat without touching elbows. You can squeeze to 55 cm for occasional guests and you will feel it. Give 65 to 70 cm and the table feels generous.
For six people seated three along each long side:
- Three settings at 60 cm each is 180 cm of edge.
- Add a little at each end so the outer two are not hanging off the corner. Call it 200 cm minimum.
- 210 to 240 cm is the comfortable band, and it is where most six-seat slabs land.
If you want to seat one person at each end instead, you are seating two along each side plus two ends, and the length drops. A 180 cm table seats six that way, but the two end chairs will be fighting the legs or the base, which is why the base choice comes into this. See legs or a trestle.
Then the width
Width decides whether the table works, more than length does.
| Width | What happens |
|---|---|
| Under 80 cm | Two people opposite each other have no middle. Serving dishes go on a sideboard. |
| 85 to 100 cm | The usual sweet spot. Two place settings plus a runway down the centre for dishes. |
| 100 to 120 cm | Generous and good for a table that also gets worked at. Needs a bigger room. |
| Over 120 cm | You cannot pass a dish across. The centre becomes permanent storage. |
On a live-edge slab the number that counts is the narrow point. A slab described as 85 to 100 cm is 85 cm somewhere, and that is where the two place settings have to fit. Read how to read a slab listing if the two numbers are confusing.
Then the room
This is the step people skip. A chair needs to come out from the table and have a person stand up in front of it.
- 75 cm behind the table edge is the minimum for pulling a chair out and sitting down.
- 90 to 100 cm lets someone walk behind a seated person.
- 120 cm is what you want on the side with the main walkway through the room.
So a 220 by 95 cm table in a room where you need to walk both sides wants roughly 220 + 180 = 400 cm in one direction and 95 + 180 = 275 cm in the other. If your room is 350 by 300 cm, the table still fits, but only with the long side against a wall or a tighter walkway on one side.
Mark the footprint on the floor with masking tape before you order anything, then put your existing chairs on the tape and sit in them. Fifteen minutes of tape has saved more tables than any measuring guide.
Working back to a slab
Slabs are not sold in finished sizes. A rough-sawn slab loses a little in flattening, and the ends usually need trimming back past the end checks that opened while it dried. A reasonable planning assumption:
- Expect to lose 5 to 15 cm of length to squaring the ends, more if the ends are badly checked.
- Expect to lose 3 to 6 mm of thickness to flattening both faces, sometimes more if the slab has a twist.
- Width stays as it is, because you are keeping the live edges.
So for a finished 220 cm table, look at slabs from about 230 cm. For a finished 240 cm, look from about 250 cm.
Three worked examples
Open-plan room, six every day, eight at Christmas. Look for 260 to 280 cm long and 95 to 110 cm wide. You seat six with room to spare and squeeze eight by adding one at each end. W-25 at 270 by 85 to 92 cm is the shape of slab this describes.
Narrow city flat, six at a push. Look for 200 to 220 cm long and 85 to 95 cm wide, and put the long side near a wall. Keep the walkway side at 100 cm and accept 75 cm on the wall side.
Table that is also a desk and a workbench. Go wider than you think: 100 to 115 cm. You lose a little of the dish-passing convenience and gain a surface two people can actually work on from opposite sides.
The one thing not to compromise
If you have to choose between length and width, keep the width. A table that is 20 cm shorter than ideal seats the same six people slightly closer together. A table that is 15 cm narrower than ideal is annoying at every single meal.
Common questions
How long does a table need to be to seat six?
About 200 cm as a minimum with three people along each side, and 210 to 240 cm for comfort. If you seat two at the ends, 180 cm can work, but only if the base leaves the ends clear.
What is the minimum width for a six-seat dining table?
Around 85 cm. Below that there is no usable centre for serving dishes, and on a live-edge slab the narrow point of the waist is the figure that matters, not the widest measurement.
How much space do I need around the table?
At least 75 cm from the table edge to the nearest wall or furniture so a chair can be pulled out, and 90 to 100 cm on any side people need to walk past.
Should I buy a slab longer than my finished table?
Yes. Allow 5 to 15 cm of length for trimming the end checks square, and a few millimetres of thickness for flattening. Width is unaffected because the live edges stay.