Collecting a Slab Yourself
Vehicle length, tie-down points, covering the load and why a slab should travel flat.
Collecting in person removes the delivery cost and the access problem, and replaces them with a different set of questions about your vehicle. Get those right and it is the simplest way to take a slab home.
Will it fit
This is the whole decision, and it is arithmetic rather than optimism.
| Slab length | Realistic vehicle |
|---|---|
| Up to 110 cm, a cross-cut round | Estate car or hatchback with seats down |
| Up to 200 cm | Large estate or small van with seats out |
| 200 to 280 cm | Medium van, or a trailer |
| 280 to 330 cm | Long wheelbase van, or a trailer with proper support |
Measure the actual load space, not the van's advertised size. Wheel arches, bulkheads and door apertures all take space, and the diagonal inside a van is not usable for something rigid.
A slab travels flat and fully supported along its length. On edge in a moving vehicle it flexes with every bump, and any existing check is worked in tension for the whole journey. Flat on a full-length board or on battens at close intervals is the only correct way to carry one.
Loading
- Bring enough people. A 300 cm walnut slab is around 110 kg. Work yours out with working out what a slab weighs.
- Protect the load bed with blankets, and protect the slab from the load bed.
- Carry it on edge, set it down flat. Method in carrying and lifting a slab safely.
- Support it along its whole length, not at the ends.
- Pack out any gap so it cannot slide forward under braking.
Tying it down
- Ratchet straps to proper anchor points, not to a seat frame or a door handle.
- Protect the edges under the straps. A ratchet strap tightened onto a live edge will crush it. Use corner protectors, a folded blanket or offcut timber.
- Strap it down and forward. The force that matters is braking, which throws the load towards the cab.
- Check the straps at the first stop. Loads settle.
Overhang and the law
If any part of the load projects beyond the vehicle, national rules apply on marking, lighting and maximum projection, and they differ between countries. Check the rules for every country you will drive through before loading, not after. A long slab in a short vehicle is the situation where this becomes relevant, and the honest answer is usually to hire a longer vehicle instead.
Weather
An open trailer needs the slab covered. Rain on kiln dried timber for a two-hour drive is not a disaster and it is not nothing either: the surface takes up moisture unevenly, which is exactly the gradient that causes movement. Sheet it properly, and secure the sheeting.
When you get it home
Same as any delivery. Inspect it in good light, then get it flat on battens in the room where it will live for two to four weeks before cutting anything. See acclimatising a slab after delivery.
One advantage of collecting: the slab has not spent days in a lorry going from cold to warm, so the environmental shock is smaller. The settling time in your house is the same regardless.
Arranging it
Say in your enquiry that you intend to collect, so the quote comes back without delivery and we can agree a time. Contact details are in the footer of every page.
Common questions
Can I collect a slab myself?
Yes. Say so in your enquiry so the quote excludes delivery and a collection time can be agreed.
What size van do I need for a 300 cm slab?
A long wheelbase van, or a trailer with full-length support. Measure the actual usable load space rather than relying on the advertised size.
Should a slab travel flat or on edge in a vehicle?
Flat and supported along its whole length. On edge it flexes with every bump and works any existing check in tension.
How do I strap a slab down without damaging it?
Use proper anchor points, put corner protectors or folded blankets under the straps so they do not crush the live edge, and strap down and forward against braking forces.