Plane Console Table From a Narrow Slab

A pale console in plane reads lighter in a dark hallway. Sizes, and what the figure does on a narrow piece.

Species and use5 min readUpdated 2026-10-23

Plane is the console species for a dark corridor. Hallways rarely have a window, and a chocolate walnut top in a hall with one warm bulb disappears into the wall. A cream top with a fine speckled figure does the opposite.

The dimensions are the same as any console and are covered in the walnut console piece. Here is what plane changes.

The figure reads best at console distance

This is the one piece where plane's ray fleck works harder than on anything else. A dining table is seen from above at a metre. A console in a corridor is seen from 40 cm away as you walk past, and at that distance the speckle is the detail your eye lands on.

On a narrow rip from a slab, the fleck is strongest in the strip nearest a live edge, where the cut runs closest to radial. If you are ripping a wide plane slab into two consoles, ask for the fleck-heavy strip if that is what you want, and expect the two halves to look different.

Pale wood in a hallway: the honest trade

A console takes hand contact more than any other piece in the house, and hands carry oil and dirt. On pale wood that shows at the front edge within months.

Three responses that work:

  • A hardwax oil with a white pigment. Keeps the colour deliberate rather than slowly greying, and disguises handling.
  • Maintain the front edge. A single re-oil of the front 10 cm once a year takes ten minutes and resets it.
  • Put a tray on it. Keys and coins on bare pale wood is how a console gets scratched and marked.

The finish comparison is in hardwax oil, lacquer or epoxy.

Plane is softer, and a console gets knocked

Plane is not as hard as oak. On a dining table that is fine. In a hallway where a bike pedal or a suitcase corner meets the edge, it dents more easily.

Two practical adjustments:

  • Ease the edges properly. A sharp arris on a soft pale wood chips. A 2 to 3 mm radius on the rip-sawn edges survives far better and feels better under the hand.
  • Keep it out of the swing of a door. Obvious, and still the most common way a hall console gets damaged.

If the hallway is genuinely rough, oak is the better species and you lose the paleness.

Length, and what plane offers

Plane slabs in stock run long. P-16 at 295 cm and P-15 and P-17 at 330 cm are all longer than most hallways want in one piece, which makes them good value for a console because you are buying the offcut too.

Typical plan from a 295 cm slab at 95 cm wide:

  • A 180 cm console at 40 cm deep, live edge to the front.
  • A second 110 cm console or a pair of floating shelves from the remaining length.
  • A narrow offcut strip from the rip, which makes a window shelf or a plant stand top.

Have the cutting planned before the slab is machined, so the fleck lands where you want it.

Plane in stock

P-16 at 295 cm by 93 to 98 cm, P-15 and P-17 at 330 cm, P-18 at 240 cm by 115 to 125 cm. 5 to 6 cm thick, kiln dried to 8 to 10 percent, supplied rough sawn.

Common questions

Will a pale console look dirty quickly?

At the front edge where hands land, yes, faster than a dark wood. It is a maintenance habit rather than a defect, and a pigmented oil slows it considerably.

Does plane have the same ray fleck as oak?

It has more of it, finer and more evenly spread. Oak gives occasional broad silver flashes; plane gives a dense speckle across the whole face. That is why it is sold as lacewood.

Is plane stable enough for a narrow top near a radiator?

Any species is at risk there, because the heat dries the underside faster than the face and cups the top. Seal all faces equally, leave an air gap, and read seasonal movement and humidity.

Pale and wide

P-16 is 295 cm long and 93 to 98 cm wide, enough for a long console with a clean rip off the back. We send photographs and a quote within a day.

See the plane