A New Crack Has Appeared: What Now

Most new cracks mean the air got dry. How to tell, how to stabilise it, and when to call it structural.

Finishing and care4 min readUpdated 2026-10-23

A crack appearing in a table you have owned for two years is alarming and usually not serious. In almost every case it is the wood telling you the air in the room changed, and the first correct action is to do nothing except measure.

First: when did it appear

Note the date. If it is January or February in a heated house, you almost certainly have a humidity problem rather than a timber problem. Dry air pulls moisture out of the wood, the wood shrinks across its width, and where it cannot shrink evenly it splits. The mechanism is in seasonal movement and humidity.

Measure the room

Buy a hygrometer and put it in the room with the table. Then read the number.

Relative humidityVerdict
Below 30 percentFound it. The air is the cause
30 to 35 percentDry. Likely contributing
35 to 55 percentNormal. Look at the fixings instead
Above 55 percentNot a drying crack. Look at the fixings and the base

Second: check the fixings

If the humidity is normal, the usual cause is a top that has been stopped from moving. Look underneath.

  • Screws through round holes in a steel base hold the width rigidly. The top cannot shrink, so it splits instead. This is the most common cause of a crack in a well-kept house.
  • A cleat or batten glued or screwed across the width does the same thing.
  • A breadboard end glued across its whole length is a guaranteed crack. Covered in breadboard ends on a slab table.

The fix is to free the top: slotted holes, Z clips or figure-eight fasteners, so the width can change while the top stays located. See Z clips, figure-eight fasteners and slotted holes.

Do not fill it yet

A crack that opened because the air got dry will close again, partly or fully, when the humidity comes back up in spring. Resin poured into it in February gets compressed in June and can push the wood apart elsewhere or crack the fill. Raise the humidity, wait for the season to turn, then look again.

What to do now

  1. Photograph it with a ruler next to it so you can tell later whether it is moving.
  2. Raise the humidity towards 40 to 45 percent if the reading was low. A humidifier through the heating season is the direct fix.
  3. Free the top if the fixings are the cause. This is urgent: a restrained top keeps splitting.
  4. Wait a season. Re-photograph in three months.
  5. Then decide whether anything needs doing.

Is it structural

Most are not. Treat it as structural if any of these are true:

  • It runs more than about a third of the way across the width.
  • It goes right through the thickness and you can see light.
  • The two sides are at different heights, which means the halves are moving independently.
  • It is lengthening measurably between photographs taken months apart in stable humidity.

Structural cracks want mechanical reinforcement, not filler. Butterfly keys across the crack, set into the underside if you do not want them visible, are the traditional and still the best answer. The method is in butterfly keys and crack repair.

Cosmetic fills, once it has settled

If after a full year the crack is stable and you simply dislike it, fill it with resin and sand flush, following filling voids and knots with resin. Accept that a rigid fill in solid wood can still be stressed by seasonal movement, so for anything wider than a few millimetres, reinforce first and fill second.

What not to do

  • Do not clamp it shut. You are fighting the whole width of the slab with a clamp. It will not hold and you can crush the edges.
  • Do not wet the wood to swell it closed. You will raise the grain, mark the finish and create a moisture gradient.
  • Do not fill in winter. See above.
  • Do not panic. Checks and movement are normal in a one-piece top, which is covered in cracks, checks and voids.

Common questions

Why has a crack appeared in my wooden table?

Usually dry indoor air in the heating season, or a top that has been screwed down rigidly and cannot shrink across its width. Measure the room humidity and look at the fixings underneath.

Should I fill a new crack in a table?

Not immediately. A crack caused by dry air will close again when humidity rises, and a fill made in winter is compressed in summer. Wait a season, then decide.

When is a crack in a slab structural?

When it runs more than about a third of the way across, goes right through the thickness, leaves the two sides at different heights, or keeps lengthening in stable humidity. Those want butterfly keys rather than filler.

Can I clamp a crack closed?

No. You are working against the whole width of the slab, the clamp will not hold it, and it can crush the edges. Fix the cause instead.

Every slab here is the only one of its kind

Walnut, oak and plane, up to 330 cm, kiln dried to 8 to 10 percent. Shortlist what fits and we send photos, measurements and a delivery quote within a day.

See slabs in stock