How Slabs Are Packed for Freight
What goes on a pallet, how edges and corners are protected, and why the wrapping is not sealed tight.
Packing a slab is a balance between two things that pull in opposite directions: it has to survive being moved by machinery, and it has to not sweat. Most of the decisions below come from that tension.
What the slab has to survive
- Forklift tines going under it at both ends of the journey.
- Other pallets next to it and sometimes above it.
- Vibration for several days.
- Temperature swings, including a cold lorry overnight and a warm depot in the afternoon.
- Rain and road spray during loading.
How it goes on the pallet
- Flat and supported along its length. A slab supported only at its ends flexes over days of vibration, and any existing check is held in tension the whole way.
- On bearers, so forklift tines pass underneath without touching the wood.
- Corners and ends protected, because those take every impact.
- Live edges protected, since they are the most fragile part and the part you are buying.
- Strapped so nothing can shift. A slab that slides inside its packaging damages itself.
- Wrapped against water and road dirt.
A slab kiln dried to 8 to 10 percent, sealed in plastic for a week in a lorry that goes from cold night to warm afternoon, arrives with condensation against the wood. That is the opposite of what you want. The wrapping keeps water and dirt off and still lets the slab breathe. If your pallet arrives looking less hermetically sealed than a parcel, that is deliberate.
Pairs and multiple slabs
A bookmatched pair such as C18 and C19 travels together, faces protected from each other, because the matching faces are the whole point of a pair and a scuff between them is not recoverable. Multiple slabs are separated rather than stacked bare.
Cross-cut rounds
A cookie is more fragile than a length-cut slab, because the grain runs radially and a cookie is naturally prone to radial cracks. Rounds such as K-01 are packed with that in mind: supported across their full face rather than on edge. The underlying behaviour is in cross-cut round side table.
What to do with the packaging
Keep it until you have inspected the slab properly indoors and in good light. If anything is wrong, the packaging is evidence of how it travelled, and a claim is much easier with it than without. Pallets are also useful: the bearers make good battens for storing the slab flat while it acclimatises.
The inspection is in what to check when the pallet arrives.
Unwrapping
- Cut straps with care. Tensioned strapping snaps towards you.
- Unwrap where you can see it, in good light, not in a dark garage.
- Do not drag the slab off the pallet. Lift it, on edge, with enough people. See carrying and lifting a slab safely.
- Get it flat on battens straight away rather than leaving it standing on edge or on the pallet.
A note on surface condition
The slab arrives rough sawn, with saw marks, surface dirt and the look of timber rather than furniture. That is correct: every one of those disappears in the first hour of flattening and sanding. Judge the slab on its structure and its grain, not on how it looks out of the wrapping.
Common questions
How is a wood slab packed for shipping?
Flat on a pallet, supported along its length, on bearers so forklift tines pass underneath, with corners, ends and live edges protected, strapped so it cannot shift, and wrapped against water without being sealed airtight.
Why is the slab not sealed in plastic?
A sealed slab sweats. Condensation forms against kiln dried wood when a lorry goes from a cold night to a warm afternoon. The wrapping keeps water off and still lets it breathe.
Should I keep the pallet and packaging?
Until you have inspected the slab indoors. It is evidence if anything is wrong, and the bearers make good battens for storing the slab flat.
Why does the slab look rough when it arrives?
It is rough sawn and unfinished. Saw marks and surface dirt disappear in the first hour of flattening and sanding.