What to Check When the Pallet Arrives

The five-minute inspection that protects you, and what to write on the delivery note if something is wrong.

Delivery in Europe4 min readUpdated 2026-10-23

You sign for condition, not just receipt. Those five minutes at the kerb, before the driver leaves, are the difference between a straightforward claim and a difficult one.

Before you sign

  1. Look at the pallet as a whole. Is it square, is it intact, are the straps still tight, has it been dropped on a corner.
  2. Check the wrapping. Tears and punctures mark where something hit it.
  3. Look at the corners and ends of the slab through or under the wrapping. These are what take impacts.
  4. Check for water. Staining on the wrapping or the pallet means it travelled wet.
  5. Photograph everything now, wrapped, on the pallet, before anything is moved. Wide shots and close-ups.
  6. Then sign, and write what you saw.
Never sign a clean delivery note on an unopened pallet

If you cannot see the slab, write "received unexamined, subject to inspection" on the note before signing, or words to that effect in the local language. A clean signature on a damaged shipment makes every later conversation harder. If there is visible damage, describe it specifically rather than writing "damaged".

After the driver has gone

Unwrap it somewhere you can see it properly, with good light, and go round the whole slab.

  • Both faces for impact marks, gouges and splits that are not in the photographs you were sent.
  • Both ends. End checks are normal in a slab and new impact damage is not. The difference is in cracks, checks and voids.
  • The live edges, which are the most delicate parts.
  • The corners.
  • Dimensions. Measure length, the three widths and the thickness against the listing.
  • Moisture, if you own a meter. It should be in the 8 to 10 percent range it left at. See moisture content explained.

Compare everything against the photographs you were sent before buying. That set of photographs is the reference for what the slab looked like when it left.

What is normal and not damage

  • Surface dirt and pallet marks. It is rough sawn timber that travelled on a lorry.
  • Existing checks, voids and bark pockets that were in the photographs.
  • Saw marks. The slab is not finished; flattening removes these.
  • Slight cup or twist. Normal in a kiln dried slab and removed during flattening, covered in flattening a slab with a router sled.
  • A small difference in measured width from the listing, because a live edge has no single width. The listing gives three measurements for that reason, explained in how to read a slab listing.

What is not normal

  • A split that runs through the thickness and was not there in the photographs.
  • Crushed or broken corners.
  • Impact gouges deeper than the flattening allowance.
  • Water staining through the wood rather than on the surface.
  • A slab that is visibly a different piece from the one you bought.

If something is wrong

Photograph it immediately, keep the packaging and the pallet, note it on the delivery paperwork, and email us the same day. The process from there is in if a slab arrives damaged.

Then get it indoors and flat

Once inspected, the slab wants to be flat on battens in the room where it will live, not left on the pallet in a garage. The reasoning is in acclimatising a slab after delivery, and moving it safely is in carrying and lifting a slab safely.

Common questions

What should I check when a wood slab is delivered?

The pallet and wrapping for impact and water, then the slab itself for new splits, crushed corners and gouges, measured against the photographs you were sent. Photograph everything before unwrapping.

Should I sign for a delivery I have not unwrapped?

Not cleanly. Write that it is received unexamined and subject to inspection, or describe any visible damage specifically, before signing.

Are cracks in a delivered slab a defect?

Checks and voids that were in the photographs are normal features of a one-piece top. A split that runs through the thickness and is not in the photographs is not.

What do I do if the slab is damaged?

Photograph it, note it on the delivery paperwork, keep the packaging and pallet, and email us the same day.

Every slab here is the only one of its kind

Walnut, oak and plane, up to 330 cm, kiln dried to 8 to 10 percent. Shortlist what fits and we send photos, measurements and a delivery quote within a day.

See slabs in stock