Plane Bar Top: Long, Wide and Pale

Plane slabs run longest of the three species, which suits a bar. What to watch for on the live edge.

Species and use5 min readUpdated 2026-10-23

If the bar has to be long and has to be one piece, plane is the species that gets you there. P-15 and P-17 are both 330 cm, longer than anything else in stock, and the price per metre is lower than walnut or oak.

Heights, depths and overhangs are shared and are in the walnut bar top piece. This is the plane case.

Why length is the plane argument

A bar is the one piece of furniture where a visible join is genuinely a problem. On a dining table a join can be designed in. On a bar, a seam runs straight down the surface people are looking at and resting on, it collects liquid, and it is where the top will eventually move against itself.

So length in one piece has real value here, and plane is where it is cheapest:

  • P-15 at 330 cm by 95 to 105 cm.
  • P-17 at 330 cm by 100 to 115 cm.

Either rips into a 45 cm deep bar top with a live edge on the front plus a 50 cm back shelf or a matching pair of floating shelves.

The live edge on a bar front

This is the detail that matters most on a plane bar and it gets overlooked.

A bar's front edge is in contact with people constantly: forearms resting on it, sleeves dragging across it, hands gripping it. An undulating bark edge there is beautiful and needs far more preparation than the same edge on a dining table.

  1. Remove all bark. Not most of it. Bark on a bar edge will come loose in use and it holds dirt.
  2. Shape and radius every point and hollow. A sharp promontory in the edge is a bruise waiting to happen at hip height.
  3. Sand it finer than the top face. Edges are felt, not seen, and plane is soft enough that a coarse scratch pattern is noticeable.
  4. Seal it as heavily as the top. The edge takes spills running off and hand oils, and on pale wood the dirt shows.

If that sounds like a lot of work, the alternative is to rip the front edge straight and put the live edge at the back, which is a legitimate and common choice on a bar.

Pale wood on a bar: the honest view

A bar is the hardest place in a house to keep a pale wood looking clean. Red wine, coffee, cola and a hundred hands on the front edge.

What makes it workable:

  • A built-up, cured finish. Not two quick coats. Four coats of hardwax oil, properly spread and fully cured.
  • A pigmented oil. White or clear pigment holds the colour deliberate and hides handling far better than a clear finish on cream wood.
  • Annual maintenance of the front strip, which is where 90 percent of the wear is.

If the bar will be used hard and nobody will maintain it, walnut hides the damage and oak resists it.

Thickness at 330 cm

A bar top is usually supported along its whole length by a wall or a cabinet, so the span argument that dominates a dining table hardly applies. Thickness here is about how the edge reads at standing height and about the overhang.

At 6 cm, which both long plane slabs are, you get a substantial edge and a top that cantilevers a comfortable knee overhang. 5 cm would look thin on a 330 cm run. See how thick should a slab table be.

Delivering a 330 cm slab

This is the practical catch. A 330 cm slab does not go round a tight corner, up a domestic staircase or through a standard door at an angle. Before ordering:

  • Measure the full route, including the diagonal at every turn. See measuring your door and stairwell.
  • Plan the lift. Work out the weight with what a slab weighs and have four people.
  • Check the delivery vehicle can reach the building, since a 330 cm pallet is not a hand-carry from a distant parking space.
Plane in stock

P-15 and P-17 at 330 cm, P-16 at 295 cm, P-18 at 240 cm by 115 to 125 cm. 5 to 6 cm thick, kiln dried to 8 to 10 percent, supplied rough sawn. Prices per slab, without VAT.

Common questions

Can I join two slabs for a bar longer than 330 cm?

Yes. Put the join over a support, not in a span, and allow for the two pieces moving independently. A bookmatched pair makes the join deliberate rather than apologetic: bookmatched pairs and river tables.

Does plane handle spills as well as oak?

It is less hard and less rot resistant, so the finish is doing more of the work and the wood underneath is less forgiving if the finish fails. Build it up and maintain it.

Is spalted plane a bad idea on a bar?

Sound spalting is fine and looks superb at close range. Soft, punky spalting on a wet surface is not, because it is porous. Check it with a fingernail before buying.

330 cm in one piece

P-15 and P-17 are the longest slabs in the yard. If the bar has to run in one unbroken piece, these are the two. We come back within a day.

See the long plane